|
|
|
Kto jest w sklepie?
Sklep przegląda 5918 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
 ;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
� During copying, held rotating at a high speed. When copying is completed, rotates at a high speed for the specified time according to the temperature in the machine, then starts rotating at a low speed. 2 OFF timing � During warm-up, stops when M2 (drum) is turned off. � After completion of warm-up, not turned off until SW2 (sub power) is turned off. b FM2 (writing section cooling) 1 ON timing Turned on when M15 (polygon) is turned on. � During copying, held rotating at a high speed in sync with M2 (drum). � When not copying, held rotating at a low speed. 2 OFF timing Not turned off until SW2 (sub power) is turned off. c FM5 (cleaner cooling) 1 ON timing Turned on when SW2 (sub power) is turned on. � During coping, held rotating at a high speed. � When copying is completed, starts rotating at a low speed after a lapse of the specified time from turning off of M7 (paper exit). After this, switching between high- and low-speed operations takes place according to the temperature in the machine. 2 OFF timing Not turned off until SW2 (sub power) is turned off. d FM6 (paper exit/F), FM7 (paper exit/R), and FM8 (main cooling/2)
ENWW
1 ON timing At the start of copying, starts rotating at a constant speed. 2 OFF timing Turned off when M7 (paper exit) is turned on. e FM9 (scanner cooling) 1 ON timing Turned on when L1 (exposure lamp) is turned on. 2 OFF timing Turned off when L1 (exposure lamp) is turned off. f FM10 (ADU reverse motor cooling) 1 ON timing Starts rotating at a constant speed when M9 (ADU reverse) is turned on. OFF timing Turned off when M9 (ADU reverse) is turned off. g FM13 (power supply cooling) 1 ON timing Starts rotating at a constant speed when SW1 (main power) is turned on. 2 OFF timing Not turned off until SW1 (main power) is turned off. h Fan air flow MFP unit explanation Other kinds of control 119
|
|
|
> |
|
